NanoDLP Shield V1.1 Expansion Board +Boost LED Driver Board + 2pcs CR-10 Endstops Limit Switch For SLA UV Cured 3D Printer Parts

NanoDLP Shield V1.1 Expansion Board +Boost LED Driver Board + 2pcs CR-10 Endstops Limit Switch For SLA UV Cured 3D Printer Parts

CLEARANCE SALE

Save US $3.07


  • VendorFYSETC 2th Store
  • Original PriceUS $23.60piece
  • SaveUS $3.07piece13% off
  • Last PriceUS $20.53piece
  • ShippingFree shipping
  • Product Rating4.8(2)





NanoDLP Shield V1.1 Expansion Board +Boost LED Driver Board + 2pcs CR-10 Endstops Limit Switch For SLA UV Cured 3D Printer Parts

Product Introduction FYS Boost LED Driver is an economical and easy to use driver with a maximum output of 60V/5A (requires you to replace the Rs resistor). By default, a 900mA ± 5% current output is available for 30W LEDs (10 parallel 3 series) modules. Features Wide 5V to 32V Input Voltage Range Maximum Boost Output Up to 60V 0.22V FB adjustable LED drive current Max. 5A Switching Current Capability Up to 93% efficiency Excellent line and load regulation Thermal Shutdown Function Built in Current Limit Function This expansion board is designed for the Raspberry Pi 3B and is used to run NanoDLP\'s light-cured 3D printers. The board contains a 9-28V to 5V circuit that provides a maximum of 3A and other interfaces required by NanoDLP. See the instructions below. Features 9V-28V to [email protected] Buck Converter DRV8825 Stepper Driver 12V Fans (cooling the Pi) 2X Endstops Controled MOS for ext LED driver I2C Connector for LCD1602 Uart Connector for Touch Screen Shutter support 5V OUT Connector for ext Board Package Listing: ‚Äč1* board 2*Endstops limit switch 1* Boost LED Driver