MEIDI Car Steering Wheel Covers Fits Outer Diameter of 37-38CM DIY Genuine Leather Braid On The Steering-Wheel Of Car

MEIDI Car Steering Wheel Covers Fits Outer Diameter of 37-38CM DIY Genuine Leather Braid On The Steering-Wheel Of Car

CLEARANCE SALE

Save US $9


  • VendorMEIDI Official Store
  • Original PriceUS $19.99piece
  • SaveUS $9piece45% off
  • Last PriceUS $10.99piece
  • ShippingFree shipping
  • Product Rating4.9(2)






12.998.1910.3916.2433.6016.7912.9926.73

Please kindly note:

This Car Steering Wheel Covers fits steering wheels with outer diameter of 37~38 cm(15 inches)

The steering wheel cover is universal. It is suitable for most car models.

If the outer diameter of your steering wheel is about 37-38cm, as showing in the attached picture, the cover can be used on your car.

Please carefully check your steering wheel before placing order. Thank you for your support.

installation method First clean the steering wheel and put the steering wheel cover on the steering wheel. Put on the line in the needle and start sewing pass the line through the inner side of the steering wheel cover, and leave 6 cm on the end rope after knotting(use for ending close).

The sewing is started from the outside of the steering wheel cover, the needle is transmitted from the outside to the inside, and the other side is the same, and the subsequent steps are the same.

When sewing to the steering wheel ,hold few stitches in the middle of the steering wheel.Then slowly tighten the rope to make the holster fit on the steering wheel

Next, take the line from the side of the steering wheel and wear 2-3 pins to bypass the plate.

Pull the line up to continue sewing and sew as in step three.

same hold few stitches in the middle of the steering wheel.Then slowly tighten the rope to make the holster fit on the steering wheel When sewing to the last stitch, it is knotted with the beginning of the line thread, and finally the knot is stuffed into the inside of the holster.