2D scan Engine work with Arduino Raspberry Pi YK-E3000H serial port command Manual PDA QR/1D/2D/ scan module Free Shipping

2D scan Engine work with Arduino Raspberry Pi YK-E3000H serial port command Manual PDA QR/1D/2D/  scan module Free Shipping

CLEARANCE SALE

Save US $10.8


  • VendorYK&SCAN Store
  • Original PriceUS $40.00piece
  • SaveUS $10.8piece27% off
  • Last PriceUS $29.20piece
  • ShippingFree shipping
  • Product Rating5.0(1)




14.4070.2059.67-60.8029.20-35.0428.80-34.2024.5045.00-46.80180.00

Symobologies :

1D : EAN-8、EAN-13、 EAN-13 2 add-on、 EAN-13 5 add-on、ISSN、ISBN、UPC-A、UPC-E、Code 11、Code 39、Code 93、Code 128、Codabar、Industrial 2 of 5、Interleaved 2 of 5、 MSI、GS1 DataBar(RSS14);

2D: PDF417、MIcroQR、Datamxtrix、QR、GS1、Aztec;

Interface : USB / TTL232 / RS232 / USB-Virtual COM ;

Scan Speed : 30 fps/second;

Operating Volate : 3.3V

Dimension : 21mm*14mm*8mm

Chapter : Interface

  • Connector

The figure below is a schematic of the E3000H connector. It uses a ZIF 12 PIN lower contact socket and is connected to the peripheral (host) with a flexible cable. The lower icon shows the size of the socket (unit: mm).

  • Flat Cable

The 12PIN flexible cable used in the E3000H connector can be designed as the same or different-sided cable according to the application. The specifications must meet the following requirements. To ensure the reliability and stability of the connection, use a reinforcing material at the connection end of the cable and reduce the impedance on the wire.

The E3000H communicates with the host computer in the following ways:

TTL TTL level signal (TTL-232): This interface accommodates most system architectures. For some systems that require an RS-232 form factor, a TTL-232 to RS-232 conversion circuit is required.  USB HID-KBW: A USB-based keyboard emulation device that can be directly connected to a PC without the need to install a driver. The TTL-232 serial communication interface available on the E3000H supports speeds from 2400bps to 115200bps. The default configuration of the serial communication interface of the E3000H is 9600bps, 8 data bits, no parity, and 1 stop bit. The hardware flow control and software flow control functions of the serial communication interface are not provided on the E3000H.

​Pin Definition

PIN#

Signal Name

I/O

Definition

1

NC

NC

-

2

VDD

-

3.3V power input

3

GND

-

GND

4

RX

input

TTL-232 input

5

TX

output

TTL-232 output

6

USB_D-

input /output

USB_D-signal

7

USB_D+

input/output

USB_D+signal

8

NG

-

Null

9

Buzz

output

10

LED

output

11

NG

-

12

nTrig

input

Development Board For E3000H:

​If you need to use the E3000H with USB cable, you could buy it with our development borad to make the test easily.