Ramps 1.6 board upgrade base on Ramps 1.4 1.5 +Mega 2560 R3 Reprap Mendel+12864 LCD Display +A4988/TMC2130 Stepper motor driver

Ramps 1.6 board upgrade base on Ramps 1.4 1.5 +Mega 2560 R3 Reprap Mendel+12864 LCD Display +A4988/TMC2130 Stepper motor driver

Ramps 1.6 board upgrade base on Ramps 1.4 1.5 +Mega 2560 R3 Reprap Mendel+12864 LCD Display +A4988/TMC2130 Stepper motor driver

  • VendorBIGTREETECH Store
  • Last PriceUS $35.85piece
  • ShippingFree shipping
  • Product Rating4.9(8)






Ramps 1.6:

Ramps 1.6 is optimized and launched based on Ramps 1.4 & Ramps 1.5 By Biqu

The Struture almost same as Ramps 1.5 , the difference is Ramps 1.6 have new 2pin connectors,which more simple and convenient to connect,also will not be burnt easily,what\'s more ,Ramps 1.6 have a good Heatsink above MOS tube in order to give a better function to heat dissipation .

Beside, the Power of Ramps 1.6 is more larger than Ramps 1.5, the largest power will be up to or 270W , and Ramps 1.5 just can be up to 200W, or samller than 200W.

Features :

  • It can be extended to LCD and other parts.

  • 5A additional security and component protection fusion

  • Applied to 5 Pololu stepper drive board

  • Design of Pololu plate pin socket can be easily replaced or removed for future design

  • I2C and SPI pins are available for future expansion

  • The LED will light when the heater has output

  • Choose 2 motors to connect to Z Prusa Mendell

Mega 2560 R3:

Operating Voltage: 5V

Input Voltage (recommended):7-12V

Input Voltage (limits):6-20V

Digital I/O Pins:54 (of which 14 provide PWM output)

Analog Input Pins:16

DC Current per I/O Pin:40 mA

DC Current for 3.3V Pin:50 mA

Flash Memory:256 KB of which 4 KB used by bootloader

SRAM:8 KB

EEPROM:4 KB

12864 LCD:

The intelligent controller includes an SD card reader, rotary encoders and a 20-character × 4 line LCD display. You can easily connect it to your RAMPS 1.4 board using "smart adapter" included.


This panel connect your RAMPS 1.4, you do not need your computer, your SD card intelligent controller power supply. All further operations, such as calibration, the axis movement can be done only with a rotary encoder intelligent controller. 3D design print without a computer, just use the G code design stored on the SD card.

1pc*Ramps 1.6

1pc*Mega 2560 R3

1pc*12864 LCD

5pcs*Drv8825/A4988/TMC2100/TMC2208(red or green)

1pc*USB

With TMC2130 SPI this option has 4pcs tmc2130 v1.1 drivers and 4pcs wires

With drv8825

With a4988 green

With a4988 red